Electric actuators, also known as electric actuators. It is a driving device that can provide linear or rotational motion, utilizing a certain driving energy source and working under a certain control signal.

Installation and maintenance of electric actuators

1. This product is not explosion-proof and should be installed in a hazardous gas environment.

2. This product can be installed indoors or outdoors, but it should be kept away from liquids such as rainwater, splashes, and direct sunlight.

3. Before installing the electric actuator, clean the pipeline and install a filter and discharge valve on the inlet side of the valve to prevent impurities such as gravel and rust.

4. Priority should be given to vertical installation. It can also be installed at any angle, but it should be ensured that the position of the cable interface is higher than the direction of the cable or wire duct to avoid water flowing into the actuator along the cable or wire duct.

5. The connection between the valve body flange and the pipeline should be kept naturally coaxial to avoid shear stress, and the connecting bolts should be evenly locked.

6. Space should be reserved for easy installation, wiring, manual operation, disassembly and maintenance.

7. In important situations, it is necessary to add bypass pipelines in case of failure or maintenance, in order to switch to manual operation.

8. The valve body needs to be insulated like the pipeline, especially when used in high-temperature media, and insulation should be strengthened. Otherwise, excessive ambient temperature may affect the normal operation of the electric actuator. The electric actuator mechanism cannot be insulated.

9. The electric actuator mechanism must not be immersed in water, and the wiring must comply with on-site construction specifications.

10. Before powering on, please pay attention to checking the required power voltage of the electric actuator to avoid damaging the motor. During maintenance, the power must be turned off.